Applications are now Open!
We are now accepting applications for the Intermediate Group of the Robotics Club.
You must have already been in the robotics club begginers group to advance to the intermediate group.
Places will be accepted based on applicants performance in the year, quality of code, enthusiasm and participation.
Applications Open: 9AM, 1st September 2017
Applications Close: 4PM, 22nd September 2017
Place Confirmation: 9AM, 30th September
Please make sure that you check your email’s junk folder in case our emails end up in there.
Below is a list of the available robot chassis and ideas that were mentioned during the meeting at the end of the beginners session on the 26th of April.
The ticks below state that the task needs to be done to make the robot work, no tick means the work has already been completed.
However you may consider creating a different robot! Most parts can be printed using our 3D printer, take a look at www.thingiverse.com for ideas etc.
Some of the robot pictures can be found https://drive.google.com/open?id=0B56l4ti1lC2oM1l3NElDWjdIY1U
If you would like to share ideas or need advice, contact Steve at email@example.com
|Henry Hoover Bot||This is an Ardunio contolled Henry Hoover robot created for remote control and semi autonomous. This will be created from scratch.||✔||✔|
|Rocky||This is a 3 wheel drive electric quad bike chassis, this will need the electronics updated and code created for autonomy and remote control.||✔|
|Granny Gadget||All hardware is done, advanced knowledge of coding is needed for GPS control of robot.||✔|
|Pioneer||All hardware is done, only programming is needed to allow the robot to solve mazes and act intelligently.||✔|
|Blackbot and Glove||Hardware has been done but needs tidying, code is then needed for the glove and the robot.||✔||✔|
|Tangerine Bot||Hardware has been done, this only needs programming.||✔|
|Roffi||This is a 3d printed, legged robot, this will need coding.||✔||✔|
|Sensor Board||All hardware has been done, only programming is needed to join all the sensors.||✔|
|Mini Infinity||Hardware and software needed for mini robot wars robot.||✔||✔|
|Robot Wars Mini League||✔||✔|
|Remote Control Cars||Hardware needs updating and software needs to be created.||✔||✔|
|Valiants||Hardware has been done, more advanced features can be programmed such as XBees communication and infrared. So the Valiants can communicate between each other.||✔|
|Open ROV||Very big job!||✔||✔|
|Small Boat||Hardware and software needs creating||✔||✔|
|Automated Window||Hardware and software needs to be created to automate the opening and closing of a window.||✔||✔|
|Microbit Robot||Creating the robot using a microbit||✔||✔|
|Sherbert Lemon||Omni Wheel chassis from RobotShop.com||✔|
|Tracked bots||Two wheel skid steer robots with motor controller, Arduino, ultrasonics, infrareds and encoders||✔|